& Finishers
(B803/B805/
D373/D374/
D636/D637)
2.9 FINISHER JAM DETECTION
Display Mode Jam What It Means
R1 to R3
Proof
Shift
Staple
Finisher
entrance
sensor late
After main machine exit sensor goes OFF,
finisher entrance sensor does not go ON even
after enough time to feed 450 mm.
Finisher
entrance
sensor lag
After finisher entrance sensor goes ON, it does
not go OFF after enough time to feed a sheet
1.5 times its length has elapsed.
R3 Proof
Proof exit
sensor late
After finisher entrance sensor goes ON, proof
exit sensor does not go ON even after enough
time to feed 450 mm.
Proof exit
sensor lag
After finisher entrance sensor goes OFF, proof
exit sensor does not go OFF even after enough
time to feed 450 mm.
To Next Page
Loading...
