Ricoh D129 - Page 1346

Finisher Jam Detection
B803/B805/D373/D374/D636/D637 74 SM
Display Mode Jam What It Means
R4 Shift
Upper tray exit
sensor late
After finisher entrance sensor goes ON, upper
tray exit sensor does not go ON even after
enough time to feed 485 mm.
Upper tray exit
sensor lag
After finisher entrance sensor goes OFF, upper
tray exit sensor does not go OFF even after
enough time to feed 650 mm.
R5 to R7 Staple
Pre-
stack tray
exit sensor lag
After finisher entrance sensor goes ON,
pre-stack tray exit sensor does not go ON even
after enough time to feed 650 mm.
Pre-stack tray
exit sensor late
After finisher entrance sensor goes ON,
pre-stack tray exit sensor does not go OFF
even after enough time to feed 1650 mm.
R8 to
R12
Booklet
Staple
(B700
Only)
Fold unit
entrance
sensor late
(S26)
The fold unit entrance sensor goes not go ON
after enough time has elapsed to feed 1.5 times
the length of the stack after the leading edge of
the stack reaches the stack present sensor
(S32).
Fold unit exit
sensor late
(S31)
The fold unit exit sensor does not go ON after
enough time has elapsed for the stack to feed
1.5 times its length from the fold position.
Fold unit exit
sensor lag
(S31)
After the fold unit exit sensor goes ON, it does
not go OFF after enough time has elapsed to
feed 442.9 mm.