Ricoh D129 - Installation: One G3 Board

G3 Interface Board Installation
D629 6 SM
1.2.2 INSTALLATION: ONE G3 BOARD
1. Remove the controller cover [A] (
x 2).
2. If the fax unit is already installed in the machine, remove the FCU (
x 4). If not, remove the
FCU cover (
x 3).
3. Attach one end (short length) of the flat cable to the connector [A] of the FCU board.
4. Attach the other end (long length) of the flat cable to the connector [B] of the CCUIF.
5. Attach the SG3 interface unit [A] (
x 3).