DF3010/
DF3070
(B802/D630)
2.2.6 ORIGINAL TRANSPORT AND EXIT
Single-Sided Originals
The feed motor feeds the separated original to the skew correction roller [A] at maximum speed.
After skew correction, the feed and transport motors feed the original through the scanning area at
a lower speed (the scanning area contains the original exposure guide [B] and DF exposure glass
[C]). After scanning, the original is fed out by the transport roller [D] and exit roller [E].
Double-Sided Originals
After skew correction, the ADF feed and transport motors drive the skew correction roller [A],
registration roller [B], transport roller [C] and the exit roller [D]. The front side of the original is then
scanned.
When the original exit sensor [E] detects the leading edge of the original, the junction gate
solenoid is activated and the junction gate [F] opens. The original is then transported towards the
inverter table.
Soon after the trailing edge of the original passes the exit sensor, the junction gate solenoid
switches off and the junction gate [F] is closed. When the original has been fed onto the inverter
table, the ADF inverter motor switches on. The original is then fed by the inverter roller [G], and
then by the skew correction roller [A] and registration roller [B] to the scanning area (where the
reverse side will be scanned).
To Next Page
Loading...
