Copy Adjustments: Printing/Scanning
SM 4-109 D129/D130
Replacement
and
Adjustment
4.16 COPY ADJUSTMENTS: PRINTING/SCANNING
4.16.1 OVERVIEW
Perform these adjustments after replacing any of the following:
Scanner Wire
Lens Block/SBU Assembly
Scanner Drive Motor
Polygon Mirror Motor
Paper Side Fence
Memory All Clear
4.16.2 PRINTING
1. Make sure paper is installed correctly in each paper tray before you start these
adjustments.
2. Use the Trimming Area Pattern (SP2-109-1, No. 14) to print the test pattern for the following
procedures.
Registration - Leading Edge/Side-to-Side
1. Check the leading edge registration [A] for each paper type and paper feed station, and
adjust it with following SP modes.
SP No. Specification
Tray: Plain SP1-001-1
0 ±9.0 mm
Tray: Thick 1 SP1-001-2
Rev. 12/27/2012
To Next Page
Loading...
