Copy Adjustments: Printing/Scanning
SM 4-113 D129/D130
Replacement
and
Adjustment
1. Laser unit [A]
2. Bracket [B] (
x2)
3. Install adjustment cam [C] (P/N: A2309003).
4. Secure positioning pin [D] (P/N A2309004) with the two screws removed with the bracket
[B]. Do not tighten the screws at this time.
5. To adjust the position of the laser unit [E]
1) Adjust the laser unit position by turning the adjustment cam. (See the illustration above.)
2) Tighten the adjustment bracket.
3) Print the trimming area pattern to check the image. If the results are not satisfactory,
repeat steps 5-1) to 5-3).
Rev. 12/27/2012
To Next Page
Loading...
