Type 5002
(D629)
The beeper sound is the same volume as the speaker sound.
The beeper sounds even if the sperker sound is turned off.
If the beeper does not sound, turn the main power switch on and off repeatedly and
do the transmission procedure 2 or 3 times.
If the beeper does not sound after turning the main switch on and off 3 times, you
need to input the settings stored in SRAM memory manually.
14. When “Ready” appears on the copy display, turn off the main power switch, and then
disconnect the flat flexible cable from the old FCU board.
15. Remove the fax unit from the main machine (
x 3).
16. Disconnect the flat flexible cable from the new FCU board.
17. Remove the speaker [A] from the fax unit (
x 1).
18. Install the speaker [A] in the fax unit as shown above (
x 2, x 2, x 1).
To Next Page
Loading...
