& Finishers
(B803/B805/
D373/D374/
D636/D637)
10. Push the stapler unit into the finisher and close the front door.
11. Do a folding test.
Switch the copier on.
Put one page of A3 or DLT paper in the ARDF.
On the copier operation panel, select booklet stapling.
Press [Start]. One sheet is folded.
12. Remove the sheet from the lower tray.
13. Hold the folded sheet with the creased side pointing down and face-up (the same way that it
came out of the finisher).
14. Referring to the diagram, determine if the skew is + [F] or - [G].
15. Open the front door of the finisher and pull the stapler unit [H] out.
16. Open the guide plate [I].
17. Turn the adjustment screw [J] to correct the amount of skew you measured from the test
sheet.
For + skew [F], turn the adjustment screw (clockwise).
To Next Page
Loading...
