& Finishers
(B803/B805/
D373/D374/
D636/D637)
If the stack is to be stapled at two positions:
The stapler movement motor moves the stapler to the front position and staples the front.
The stapler movement motor moves the stapler to the rear and the stapler staples the rear.
If the stack is stapled at the rear with a diagonal staple, the staple moves to the rear. When it is
time for stapling, the rotation motor rotates the stapler to the correct angle and holds the stapler in
that position while the stapler fires.
The stapling positions can be fine adjusted with SP6-133-001.
2.5.3 CORNER STAPLING
Staple firing is driven by the stapler motor [A] inside the stapler unit. The stapler hammer [B] fires
the stapler [C].
The cartridge set sensor [D] detects the cartridge at the correct position.
The staple end sensor [E] detects the staple end condition.
To Next Page
Loading...
