and
Adjustment
2. Print the test pattern "Hounds Tooth Check (2-Dot Horizontal)" (No. 16 in SP2109-001).
3. Check if the vertical stripes appear on the second pattern (counted from the leading edge)
of the printout.
Correct: No vertical stripes appear (see the sample following this procedure.)
Wrong: Vertical stripes appear (see the sample following this procedure.)
4. Turn the adjustor screw [B] by 90 degrees clockwise (counterclockwise).
If the image of the printout is getting worse, try reverse rotation (clockwise
counterclockwise)
5. Print the test pattern and check it out.
6. Try steps 2 to 4 again until you get an image with no vertical stripes.
7. Reassemble the machine after completing this adjustment.
Correct: No vertical stripes appear
To Next Page
Loading...
