and
Adjustment
6. Tip out the old developer [C].
7. Turn drive gear [D] to ensure that no developer remains in the unit or on the developer
roller.
Dispose of the used developer in accordance with local regulations. Work carefully
to avoid scratching or nicking the development roller.
8. Clean the development roller with a dry cloth.
9. Pour approximately 1/3 of the developer [E] evenly along the length of the development
unit.
10. Rotate the drive gear [F] to work the developer into the unit.
11. Repeat steps 8 and 9 until all toner is in the unit and level with the edges.
12. Re-install the development roller.
Make sure that the seals at the both sides of the development roller are set inside
the case after you re-install the development roller.
To Next Page
Loading...
