Main SP Tables-1
D129/D130 5-6 SM
1105*
Fusing Temperature Adjustment
Allows adjustment of the hot roller temperature at the center and ends of the
roller for the quality or thickness of the paper. The hot roller in this machine
has two fusing lamps: one heats the center of the roller, the other heats both
ends. Each fusing lamp can be adjusted separately.
The "re-load temperature" is the "print ready temperature". When the fusing
temperature exceeds this setting, the machine can operate. Do not set up a
re-load temperature (Re-load Temp. = Fusing. Temp – SP Value.) that is
higher than the SP1-105-2 setting.
001
Roller Center
C2b: [100 to 170 / 140 / 1 deg]
C2c: [100 to 170 / 150 / 1 deg]
Adjusts the fusing temperature at the center of the hot roller.
002
Roller Ends
C2b: [100 to 170 / 145 / 1 deg]
C2c: [100 to 170 / 155 / 1 deg]
Adjusts the fusing temperature at the ends of the hot roller.
003
Re-load Temp. Minus: Roller Center [0 to 60 / 0 / 1 deg]
Sets the reload temperature for the center of the hot roller. This setting
depends on the target temperature.
Reload temp. = Target Temp – This SP Setting
Do not set a temperature that is higher than the setting for SP1105 1
(Roller Center: Trays)
004
Re-load Temp. Minus: Roller Ends [0 to 60 / 0 / 1 deg]
Sets the reload temperature for the ends of the hot roller. This setting depends
on the target temperature.
Reload temp. = Target Temp – This SP Setting
Do not set a temperature that is higher than the setting for SP1105 2
(Roller Ends: Trays)
005 to
022
The following SPs adjust the fusing temperature at the center or ends of the
hot roller for each paper type.
To Next Page
Loading...
