Main SP Tables-4
D129/D130 5-20 SM
4013
Scanner Free Run
Performs a scanner free run with the exposure lamp on or off.
001 Lamp: OFF
[0 to 1 / 0 / 1]
0=Off, 1=On
002 Lamp: ON
4014 Scan
001 HP Detection Enable Scanner free run with HP sensor check.
002 HP Detection Disable Scanner free run without HP sensor check.
4020*
Dust Check
This function checks the narrow scanning glass of the ADF for dust that can
cause black lines in copies. If dust is detected a system banner message is
displayed, but processing does not stop.
001
Dust Detect: On/Off
Issues a warning if there is dust on the narrow scanning glass of the ADF
when the original size is detected before a job starts. This function can
detect dust on the white plate above the scanning glass, as well as dust on
the glass. Sensitivity of the level of detection is adjusted with SP4020-2.
[0 to 1 / 1 / 1]
0: Off. No dust warning.
1: On. Dust warning. This warning does not stop the job.
Before switching this setting on, clean the ADF scanning glass and
the white plate above the scanning glass.
002
To Next Page
Loading...
