Main SP Tables-5
SM 5-73 D129/D130
Active IPv4 Gateway Address
This SP allows you to check the IPv4 default gateway setting that was used
when the machine started up with DHCP.
050
1284 Compatibility
(Centro)
Enables and disables bi-directional
communication on the parallel connection
between the machine and a computer.
[0 to 1 / 1 / 1 ]
0:Off, 1: On
052
ECP (Centro)
Disables and enables the ECP feature (1284
Mode) for data transfer.
[0 to 1 / 1 / 1]
0: Disabled, 1: Enabled
065
Job Spooling
Switches the job spooling on and off.
[0 to 1 / 0 / 1]
0: No spooling, 1: Spooling enabled
066
Job Spooling Clear: Start
Time
This SP determines whether the job interrupted
at power off is resumed at the next power on.
This SP operates only when SP5828-065 is set
to "1".
[0 to 1 / 1 / 1]
1: OFF Resumes printing spooled jog.
0: ON Clears spooled job.
069
Job Spooling (Protocol)
This SP determines whether job spooling is
enabled or disabled for each protocol. This is a
8-bit setting.
[0 to 1 / 1 / 1]
0: No spooling, 1: Spooling enabled
0 LPR 4 BMLinks (Japan Only)
1 FTP (Not Used) 5 DIPRINT
2 IPP 6 Reserved (Not Used)
3 SMB 7 Reserved (Not Used)
To Next Page
Loading...
