Main Machine Installation
D129/D130 2-12 SM
10. Pour the developer [9] into the development unit.
The developer lot number is embossed on the end of the developer package. Do
not discard the package until you have recorded the lot number. (
p.4-46
"Developer")
1) Pour approximately 1/3 of the developer evenly along the length of the development unit.
2) Rotate the drive gear [10] to work the developer into the unit.
3) Repeat until all the developer is in the development unit.
4) Continue to turn the drive gear until the developer is even with the top of the unit.
11. Put the opening cap [4] back in its original place.
12. Reassemble the PCDU.
13. Re-install the PCDU.
To Next Page
Loading...
