Ricoh D129 - Page 535

Service Call Conditions
D129/D130 6-46 SM
822 B Self-diagnostic error: HDD
[3003]
Check performed only when HDD is installed:
 HDD device busy for over 31 s.
 After a diagnostic command is set for the HDD, but the device remains
busy for over 6 s.
 HDD defective
 HDD harness disconnected, defective
 Controller board defective
[3004]
No response to the self-diagnostic command from the ASIC to the HDDs.
 HDD defective
823 B
Self-diagnostic error: NIB
[XXXX]: Detailed error code
[6101]
MAC address check sum error
The result of the MAC address check sum does not match the check sum
stored in ROM.
[6104]
PHY IC error
The PHY IC on the controller cannot be correctly recognized.
[6105]
PHY IC loop-back error
An error occurred during the loop-back test for the PHY IC on the controller.
824 D
Self-diagnostic error : NVRAM
NVRAM device does not exist, NVRAM device is damaged, or NVRAM
socket damaged.
 NVRAM defective
 Controller board defective
 NVRAM backup battery exhausted
 NVRAM socket damaged