shooting
861 D
HDD re-try failure
At power on, the HDD is detected. Power supply to the HDD is interrupted
after the system has entered the energy save mode, but after the HDD has
been awakened from the energy save mode, it does not return to the ready
status within 30 sec.
Harness between HDD and controller board disconnected, defective
HDD power connector disconnected
HDD defective
Controller board defective
862 D
Bad sector number error
The number of bad sectors in the HDD (image data area) goes over 101.
Defective HDD
Format the HDD with SP5-832-002.
Replace the HDD.
863 D HDD data read failure
- -
The data written to the HDD cannot be read normally, due to bad sectors
generated during operation.
Note: [001] to [017] indicate the type of partition where the error occurred.
Enable display of these numbers with SP7902.
[001] An area which does not belong to a partition
[002] a partition
[003] b partition
[004] c partition
[005] d partition
[006] e partition
[007] f partition
To Next Page
Loading...
