Service
Program
Mode Tables
012 LCT: Plain
[-9 to 5 / -4 / 1 mm step]
013 LCT: Thick1
014 LCT: Thick2
1007*
By-pass Paper Size Detection
Controls paper size detection for the by-pass feed table.
001 Detection Timing [-15 to 15 / 0 / 5 mm step]
002 LG Detection
[0 to 1 / 0 / 1]
0: LT SEF, 1: LG
1103*
Fusing Idling
Switches fusing idling on/off. When on, printing will not start until enough
time has elapsed so the hot roller can reach optimum temperature. This
ensures even heat on the hot roller.
Switch on if fusing on the 1st and 2nd copies is incomplete (this may occur if
the room is cold.). You must switch SP1103-1 ON before you set the fusing
interval with SP1103-2.
001 Enable Fusing Idling 0 = Off, 1 = On
002 Interval [0 to 60 / 30 / 1 sec.]
003 Idling Time at Every Job
Sets the machine to fusing idling only for 30
sec. for every job (when the original is set on
the ARDF, when the ARDF cover is opened,
etc.) and the fusing unit has reached the
reload temperature (optimum temperature for
operation).
[0 to 30 / 0 / 1 sec.]
0: No idling done before a job.
To Next Page
Loading...
