Component Layout
B802/D630 22 SM
-
Original Length -
M
Detects the original length - M. 12
- Original Length - L Detects the original length - L. 13
- Original Set Detects if an original is on the feed table. 16
- Original Exit
on the junction gate solenoid and checks for
original misfeeds.
Detects the trailing edge of the original to turn
off the transport and feed motor and junction
gate solenoid.
In single-sided mode, used to detect original
misfeeds.
19
-
Original Trailing
Edge Sensor
Detects the trailing edge of the last original to
stop copy paper feed and to turn off the
transport motor, and checks for original
misfeeds.
15
-
Separation
Sensor
The machine uses this sensor to check if the
original has slipped during feed-in, to make
sure that original feed starts at the correct
time.
18
Solenoids
- Stamp Energizes the stamper to mark the original. 17
- Junction Gate Opens and closes the junction gate. 20
PCBs
- DF Drive
Interfaces the sensor signals with the copier,
and transfers the magnetic clutch, solenoid
and motor drive signals from the copier.
14
To Next Page
Loading...
