3. Press “Startup”, then stop all applications.
The following problems can occur if the VM firmware is updated without the
application halt.
The VM firmware update fails.
All settings for the application are cleared.
4. Turn the main switch off, then remove the card slot cover.
5. Remove the VM SD card from the SD card slot.
Updating the VM SD card
1. Insert the SD card into the SD card writer that is connected to a PC.
2. Make sure which drive is assigned for the SD card.
3. Decompress the downloaded update file, then there are two files (one file has an “.exe” file
extension and the other has a “.bat” file extension).
4. Double click the “.bat” file, then the command prompt screen appears.
5. The first command line is shown as
“Please input drive letter of SD card [a – x]:”
Then enter the SD card drive name, and press the “Enter” key.
6. “Press any key to continue…” appears, then press the “Enter” key again. The update to the
SD card starts.
7. “Press any key to continue…”appears again, then press “Enter” key. The command prompt
screen disappears automatically if the update is successful.
8. Remove the SD card from the SD card writer after the access lamp going off on the SD card
writer.
9. Insert the SD card in the SD card slot 2 of the machine and turn the main switch on.
Starting the application
1. Press the “User Tools/Counter” key, then touch “Extended Feature Settings” twice on the LCD.
If required, log in as a machine administrator.
2. Press “Startup Setting”, then change the status to “Starting up” for each application.
3. Press “Exit”.
4. Press “Administrator Tools”, then press “Heap/Stack Size Settings”. Program the heap size
and stack size as the settings as before.
5. Turn the main switch off and on.
6. Enter the “Extended Feature Settings” menu again, and check the version of the VM card
firmware on the “Extended Feature Info” screen.
The version of the VM card firmware is also shown on the Self Diagnostic Report (a part
of the SMC report). But the version on the Self Diagnostic Report is not changed after
updating.
To Next Page
Loading...
