Ricoh D158 - By-Pass Paper Width Sensor; When Replacing the By-Pass Paper Width Sensor

Paper Feed Section
D158/D159/D160/D161/D170 4-74 SM
4.9.17 BY-PASS PAPER WIDTH SENSOR
1. By-pass tray unit ( p.4-16)
2. By-pass left tray cover [A] (hook x 1)
3. Replace the by-pass paper width sensor [A] (
x 1).
When replacing the by-pass paper width sensor
1. Align the holes [A], [B] and [C].
2. Install the by-pass paper width sensor [D].
3. Reassemble the copier.
4. Plug in and turn on the main power switch.
5. Check the switch operation with SP5-803-046 (By-Pass Size Detection SW < Input Check).