Fax Option Installation
D702 2 SM
1.1.2 FAX OPTION INSTALLATION PROCEDURE
Before installation:
If there is a printer option in the machine, print out all data in the printer buffer.
Turn the main switch on to put the machine in standby mode. Make sure the power LED
is off, turn the main switch off, and then disconnect the power cord and the network
cable.
The copier must be connected to a properly grounded socket outlet.
1. Rear cover [A] (
x 9)
2. Five screws
Small arrows carved in the frame indicate the screws to remove.
1. Slide the engine board [A] to the left as shown, to detach it from the controller board [B].
To Next Page
Loading...
