Ricoh D158 - Test Pattern Printing; D158;D159

Test Pattern Printing
SM Appendix 3-281 D158/D159/D160/D161/D170
Appendix:
Service
Program
Mode Tables
3.12 TEST PATTERN PRINTING
3.12.1 D158/D159
Printing Test pattern: SP2-109
Some of these test patterns are used for copy image adjustments but most are used primarily for
design testing.
 Do not operate the machine until the test pattern is printed out completely. Otherwise, an
SC occurs.
1. Enter the SP mode and select SP2-109-001.
2. Enter the number for the test pattern that you want to print and press [#].
3. When you want to change the density of printing a test pattern, select the density with
SP2-109-002.
4. When you are prompted to confirm your selection, touch "Yes" to select the test pattern for
printing.
5. Touch "Copy Window" to open the copy window, then select the settings for the test print
(paper size etc.).
6. Press the "Start" key to start the test print.
7. After checking the test pattern, touch "SP Mode" on the LCD to return to the SP mode display.
8. Reset all settings to the default values.
9. Touch "Exit" twice to exit SP mode.
No. Pattern No. Pattern
0 (No print) 10 Trimming Area
1 Vertical Lines (Single Dot) 11 Argyle Pattern (Single Dot)
2 Horizontal Lines (Single Dot) 12 Grayscales (Horizontal)
3 Vertical Lines (Double Dot) 13 Grayscales (Vertical)
4 Horizontal Lines (Double Dot) 14 Grayscales (Vertical/Horizontal)
5 Grid Pattern (Single Dot) 15
Grayscales (Vertical/Horizontal
Overlay)
6 Grid Pattern (Double Dot) 16
Grayscales With White Lines
(Horizontal)