Using SP Modes
D158/D159/D160/D161/D170 6-18 SM
- Without SD Card -
1. Print out all SMC data lists (
p.6-37).
2. Select SP5-801-002.
3. Press the OK key.
4. Select "Execute" The messages "Execute?" followed by "Cancel" and "Execute" show.
5. Select "Execute".
6. When the program has ended normally, the message "Completed" is displayed. If the
program has ended abnormally, an error message shows.
7. Turn the main switch off and on.
8. Adjust the printer and scanner registration and magnification (
p.4-105 "Copy Adjustments
Printing/Scanning").
9. Refer to the factory SMC lists, and enter any values that differ from the factory settings.
10. Initialize the TD sensor (SP2-801-001 (Developer Initialization))
11. Check the copy quality and the paper path.
6.4.4 INPUT CHECK
Input Check Table for Copier (D160/D161/D170)
- Conducting an Input Check -
1. Select SP5-803.
2. Select the number (see the table below) corresponding to the component.
3. Select "Execute." The copy mode is activated.
4. Either "01H" or "00H" appears (see the table below).
Num. Sensor/Switch 00H 01H
001 Safety SW OFF ON
002 Safety SW-LD 5V OFF ON
003 Right Cover SW Closed Open
004 Right Low Cover SW Closed Open
006 Upper Relay S Not detected Paper detected
007 Lower Relay S Not detected Paper detected
009 Registration Sensor Not detected Paper detected
010 Exit Sensor Not detected Paper detected
To Next Page
Loading...
