Test Pattern Printing
D158/D159/D160/D161/D170 3-282 SM Appendix
7 Alternating Dot Pattern 17
Grayscales with White Lines
(Vertical)
8 Isolated one dot 18
Grayscales with White Lines
(Vertical/Horizontal)
9 Black Band (Horizontal) - -
3.12.2 D160/D161/D170
Printing Test pattern: SP5-902
Some of these test patterns are used for copy image adjustments but most are used primarily for
design testing.
Do not operate the machine until the test pattern is printed out completely. Otherwise, an
SC occurs.
1. Enter the SP mode and select SP5-902-001.
2. Enter the number for the test pattern that you want to print and press [#].
3. When you are prompted to confirm your selection, touch "Yes" to select the test pattern for
printing.
4. Touch "Copy Window" to open the copy window, then select the settings for the test print
(paper size etc.).
5. Press the "Start" key to start the test print.
6. After checking the test pattern, touch "SP Mode" on the LCD to return to the SP mode display.
7. Reset all settings to the default values.
8. Touch "Exit" twice to exit SP mode.
No. Pattern No. Pattern
0 None 11 Independent Pattern (1dot)
1 Vertical Line (1dot) 12 Independent Pattern (2dot)
2 Vertical Line (2dot) 13 Independent Pattern (4dot)
3 Horizontal Line (1dot) 14 Trimming Area
4 Horizontal Line (2dot) 15 Black Band (Horizontal)
5 Grid Vertical Line 16 Black Band (Vertical)
To Next Page
Loading...
