Ricoh D158 - Reassembling the Rear Scanner Wire

Scanner Unit (D158/D159)
D158/D159/D160/D161/D170 4-35 SM
Replacement
and
Adjustment
Reassembling the Rear Scanner Wire
1. Pass the wire end with a ball (A) through the scanner drive pulley as shown below.
2. Position the center ball [A] in the middle of the forked holder.
3. Wind the end with the ring clockwise (shown from the machine’s front) three times; wind the
ball end clockwise (shown from the machine’s front) five times.
 The two blue marks [A] should meet when you have done this.