Scanner Unit (D158/D159)
D158/D159/D160/D161/D170 4-36 SM
4. Stick the wire to the pulley with tape, so you can easily handle the pulley and wire during
installation.
5. Install the drive pulley on the shaft.
Do not secure the scanner wire bracket with the screw at this time (before step 7).
6. Install the wire.
The winding of the wire on the three pulleys at the rear of the scanner should be the
same as the winding on the three pulleys at the front. This must show as a mirror
image. Example: At the front of the machine, the side of the drive pulley with the
three windings must face the front of the machine. At the rear of the machine, it must
face the rear.
7. Adjust the scanner position (
p.4-37).
After replacing the scanner wire, do the image adjustments in the following section of
the manual (
p.4-105 "Copy Adjustments Printing/Scanning").
To Next Page
Loading...
