Dedicated Transmission Parameters
D702 126 SM
6-7
ECM during transmission
Bit 7: 0, Bit 6: 0 = Off
Bit 7: 0, Bit 6: 1 = On
Bit 7: 1, Bit 6: 0 = Not used
Bit 7: 1, Bit 6: 1 = Disabled
For example, if ECM is switched on but is not
wanted when sending to a particular terminal, use
the (0, 0) setting.
V.8/V.34 protocol and JBIG compression
are automatically disabled if ECM is
disabled.
If the setting is "Disabled", the bit switch
setting is used.
Switch 04 - Not used (do not change the settings)
Switch 05 - Not used (do not change the settings)
Switch 06 - Not used (do not change the settings)
Switch 07 - Not used (do not change the settings)
Switch 08 - Not used (do not change the settings)
Switch 09 - Not used (do not change the settings)
E-mail Parameters
The initial settings of the following e-mail parameters are all "0" (all parameters disabled).
Switch 00
No FUNCTION COMMENTS
0
MH Compression mode
for e-mail attachments
0: Off
1: On
Switches MH compression on and off for files
attached to e-mails for sending.
1
MR Compression mode
for e-mail attachments
0: Off
1: On
Switches MR compression on and off for files
attached to e-mails for sending.
2
MMR Compression
mode for e-mail
attachments
0: Off
1: On
Switches MMR compression on and off for files
attached to e-mails for sending.
3-6 Not used Do not change these settings.
To Next Page
Loading...
