TYPE M1
(D702)
The arrow in the picture above indicates the screw that is added to fasten the FCU.
1. Attach the board cover [A] as shown below. (
x 4)
2. Connect the telephone cord to the LINE jack.
3. Attach the Fax decal near the function key on the operation panel.
1.1.3 FAX SETTINGS
Initializing the Fax unit
When you press the Fax key for the first time after installation, the error "SRAM problem occurred
/ SRAM was formatted" will show on the LCD for initializing the program of the fax unit. Turn the
main power switch off/on to clear the error display.
If another error occurs after initialization, this can be a functional problem.
1. Select fax SP1-101-016 and specify the country code.
2. Select fax SP3-101-001 and specify the service station.
For Fax option only (without printer/scanner option)
1. Turn the main switch on.
2. Start the SP mode.
3. Select SP5-985-001 (NIC setting) and change the setting value to "0" (OFF).
4. Select SP5-985-002 (USB setting) and change the setting value to "0" (OFF).
Turn the main switch off and on.
To Next Page
Loading...
