Controller Options
D158/D159/D160/D161/D170 2-104 SM
Make sure that the FCU is seated correctly. If not, SC672 occurs.
13. Remove the jumper [A] (set to OFF) and set it to ON.
The machine may issue SC819 or SC820 if the jumper is not set to "ON" correctly.
For installation in Brazil, move the jumper switch (CN613) from "3" to "1"
14. Cut the knockouts for LINE and TEL from the controller slot cover.
15. Install the controller board in the machine
16. Fasten the five circled screws.
To Next Page
Loading...
