Scanner Unit (D158/D159)
D158/D159/D160/D161/D170 4-38 SM
6. Fasten the rear scanner wire using screws in the same manner as you have done for the front
scanner wire.
7. Pull out the positioning pins.
8. Reassemble the machine and check the operation.
Make sure the 1st and 2nd carriages move smoothly after you remove the
positioning pins.
After replacing the scanner wire, do the image adjustments in the following section of
the manual (
p.4-105 "Copy Adjustments Printing/Scanning").
To Next Page
Loading...
