Tables
GDI (Printer/Scanner)
An SD card is used to update the controller firmware.
1. Setup a folder on the SD card, "model name”(E.g., "D161").
2. Re-name the update file to“D161*****.brn”, and save under the relevant folder on the SD
Card.
The name of the new firmware saved in the SD card should be made up of numbers
‘0’ to ‘9’ or characters “A” to “Z”. E.g., “D16103A34.brn” is correct, “D161_03A4.brn”
is incorrect.
3. Remove the slot cover [A] (
x 1).
4. Insert the SD card into SD Card Slot 2 [B]. Make sure the label on the SD card faces the front
side of the machine.
5. Turn the update switch (SW2) [A] on.
To Next Page
Loading...
