11. Set the holder (with the toner bottle) in the machine.
12. Pull out the paper tray [A], and then adjust the positions of the end and side guides (
x 1).
To move the side guides, release the green lock on the rear side guide.
13. Install the optional ARDF, or platen cover.
14. Plug in the main power cord and turn on the main switch.
15. Activate the SP mode and execute "Developer Initialization" (SP2-801-001).
16. Wait until the message "Completed" shows (about 20 seconds).
17. Activate the User Tools and select the “Language” menu.
To Next Page
Loading...
