Main SP Tables-2
D158/D159/D160/D161/D170 3-26 SM Appendix
2301
[Tr Current Adj] (D160/D161/D170)
-
001
Normal Paper *ENG
[-2 to 2 / 0 / 1 / step]
Adjusts the current applied to the transfer roller when feeding from a paper
tray. Use a high setting if the user normally feeds relatively thick paper (within
spec) from a paper tray.
002
Thick/Special *ENG
[-2 to 2 / 0 / 1 / step]
Adjusts the current applied to the transfer roller when feeding from the by-pass
tray. Use a high setting (a) if the user normally feeds relatively thick paper from
the by-pass tray, or (b) if waste toner is re-attracted from the drum (which can
occur when using transparencies).
003
Duplex *ENG
[-2 to 2 / 0 / 1 / step]
Adjusts the current applied to the transfer roller when carrying out a duplex job.
Use this SP if there is poor image transfer on the rear side of duplex copies.
004
Cleaning/Negative *ENG
[-10 to 1 / -4 / 1 uA/ step]
Adjusts the current applied to the transfer roller for roller cleaning. Increase the
current if toner remains on the roller after cleaning. (Remaining toner may
cause dirty background on the rear side.)
005 Cleaning/Positive *ENG
[0 to 20 / 10 / 1 uA/ step]
006 Input/1sude *ENG
[0 to 30 / 0 / 1 uA/ step]
007 Input/2side *ENG
[0 to 30 / 0 / 1 uA/ step]
008 Non Image Area *ENG
[0 to 30 / 10 / 1 uA/ step]
009 Inside Temp *ENG
[0 to 99 / 20 / 1 deg / step]
To Next Page
Loading...
