Ricoh D158 - Page 631

Main SP Tables-5
SM Appendix 3-173 D158/D159/D160/D161/D170
Appendix:
Service
Program
Mode Tables
5857 [Save Debug Log] (D158/159)
001
On/Off (1:ON 0:OFF) *CTL
[0 or 1 / 0 / 1/step]
0: OFF, 1: ON
Switches the debug log feature on and off. The debug log cannot be captured
until this feature is switched on.
002
Target (2: HDD 3: SD) *CTL
[2 or 3 / 2 / 1/step]
2: HDD, 3: SD Card
Selects the storage device to save debug logs information when the
conditions set with SP5-858 are satisfied.
005
Save to HDD *CTL
[-999999 to 999999 / 0 / 1/step]
Specifies the decimal key number of the log to be written to the hard disk.
006
Save to SD Card *CTL
[-999999 to 999999 / 0 / 1/step]
Saves the debug log of the input SC number in memory to the SD card.
009
Copy HDD to SD
Card(Latest 4MB)
*CTL
[- / - / -]
[Execute]
Takes the most recent 4 MB of the log written to the hard disk and copies
them to the SD Card.
A unique file name is generated to avoid overwriting existing file names on
the SD Card. Up to 4MB can be copied to an SD Card. 4 MB segments can
be copied one by one to each SD Card.
010
Copy HDD to SD
Card(Latest 4MB Any Key)
*CTL
[- / - / -]
[Execute]
Takes the log of the specified key from the log on the hard disk and copies it
to the SD Card.
A unique file name is generated to avoid overwriting existing file names on
the SD Card. Up to 4 MB can be copied to an SD Card. 4 MB segments can
be copied one by one to each SD Card. This SP does not execute if there is
no log on the HDD with no key specified.