Service
Program
Mode Tables
More than the standard number of sheets can be stapled. This SP sets the
additional number of sheets (This Setting + Standard Number = maximum
number of sheets).
If the number of the maximum for staples is increased, and the mechanical
warranty of the unit can be guaranteed, then the setting can take effect
without changing the controller software.
However, assurance that mechanical performance can be guaranteed is
required before changing the setting to increase the staple load for more
than the maximum in the feed/exit specifications. Raising this setting
without quality assurance could damage the machine.
001
Staple positions other than
booklet stapling
*CTL
[0 to 50 / 0 / 1 / step]
002 2 Booklet stapling *CTL
[0 to 50 / 0 / 1 / step]
6890 [Permits punching] (D158/159)
001
- CTL
[1 or 0 / 0 / 1 / step]
0: Disable, 1: Enable
Permits punching, including tab sheets.
To Next Page
Loading...
