Printer SP Tables
SM Appendix 3-271 D158/D159/D160/D161/D170
Service
Program
Mode Tables
bit 2
Job Cancel Disabled
(Not
cancelled)
Enabled
(Cancelled)
If this bit switch is enabled, all jobs will be cancelled after a jam occurs.
Note: If this bitsw is enabled, printing under the following conditions might
result in problems:
- Job submission via USB or Parallel Port
- Spool printing (WIM >Configuration > Device Settings > System)
bit 3
PCL/PS bypass tray paper rotation
(SEF/LEF)
Disabled
Enabled
This bitsw causes the device to revert to the behavior of previous
generations. It only takes effect if "Bypass Tray Setting Priority" =
"Driver/Command".
Previous spec (bitsw=1): If a standard sized paper mismatch occurred in the
bypass tray, the MFP always prompted for SEF paper.
If this bitsw=0 (default) then in the event of a standard sized paper mismatch,
the MFP will always prompt for paper of the rotation (SEF/LEF) determined
by the MFP bypass tray paper setting or by the bypass tray sensor.
bit 4
Timing of the PJL Status ReadBack (JOB
END) when printing multiple collated
copies.
Disabled
Enabled
This bitsw determines the timing of the PJL USTATUS JOB END sent when
multiple collated copies are being printed.
0 (default): JOB END is sent by the device to the client after the first copy has
completed printing. This causes the page counter to be incremented after the
first copy and then again at the end of the job.
1: JOB END is sent by the device to
the client after the last copy has finished
printing. This causes the page counter to be incremented at the end of each
job.
To Next Page
Loading...
