FCU
D702 16 SM
12. Connect the flat flexible cable to the old FCU board [A].
13. Turn on the main power switch.
14. SRAM data transmission starts. When the transmission is completed, you will hear a beeper
sound.
The beeper sound is the same volume as the speaker sound.
The beeper sounds even if the sperker sound is turned off.
If the beeper does not sound, turn the main power switch on and off repeatedly and
do the transmission procedure 2 or 3 times.
If the beeper does not sound after turning the main switch on and off 3 times, you
need to input the settings stored in SRAM memory manually.
15. When “Ready” appears on the copy display, turn off the main power switch, and then
disconnect the flat flexible cable from the old FCU board.
16. Disconnect the flat flexible cable from the new FCU board.
17. Reattach the controller slot cover (
x 6).
To Next Page
Loading...
