Ricoh D158 - Page 865

Error Codes
SM 23 D702
FAX OPTION
TYPE M1
(D702)
Code Meaning Suggested Cause/Action
0-33 The data reception (not ECM)
is not completed within 10
minutes.
 Check the line connection.
 The other terminal may have a defective
modem/FCU.
0-52 Polarity changed during
communication
 Check the line connection.
Retry communication.
0-55 FCU does not detect the
SG3.
 FCU firmware or board defective.
 SG3 firmware or board defective.
0-56 The stored message data
exceeds the capacity of the
mailbox in the SG3.
SG3 firmware or board defective.
0-70 The communication mode
specified in CM/JM was not
available
(V.8 calling and called
terminal)
 The other terminal did not have a
compatible communication mode (e.g.,
the other terminal was a V.34 data modem
and not a fax modem.)
 A polling tx file was not ready at the other
terminal when polling rx was initiated from
the calling terminal.
0-74 The calling terminal fell back
to T.30 mode, because it
could not detect ANSam after
sending CI.
 The calling terminal could not detect
ANSam due to noise, etc.
 ANSam was too short to detect.
 Check the line connection and condition.
 Try making a call to another V.8/V.34 fax.
0-75 The called terminal fell back
to T.30 mode, because it
could not detect a CM in
response to ANSam (ANSam
timeout).
 The terminal could not detect ANSam.
 Check the line connection and condition.
 Try receiving a call from another V.8/V.34
fax.
0-76 The calling terminal fell back
to T.30 mode, because it
could not detect a JM in
response to CM
(CM timeout).
 The called terminal could not detect a CM
due to noise, etc.
 Check the line connection and condition.
 Try making a call to another V.8/V.34 fax.