Ricoh D158 - Page 867

Error Codes
SM 25 D702
FAX OPTION
TYPE M1
(D702)
Code Meaning Suggested Cause/Action
0-85 The line was disconnected
due to abnormal signaling in
V.34 control channel restart.
 The signal did not stop within 10 s.
 Turn off the main power switch, then turn it
back on.
 If the same error is frequent, replace the
FCU.
0-86 The line was disconnected
because the other terminal
requested a data rate using
MPh that was not available in
the currently selected symbol
rate.
 The other terminal was incompatible.
 Ask the other party to contact the
manufacturer.
0-87 The control channel started
after an unsuccessful primary
channel.
 The receiving terminal restarted the
control channel because data reception in
the primary channel was not successful.
 This does not result in an error
communication.
0-88 The line was disconnected
because PPR was
transmitted/received 9
(default) times within the
same ECM frame.
 Try using a lower data rate at the start.
 Try adjusting the cable equalizer setting.
2-11 Only one V.21 connection flag
was received
 Replace the FCU.
2-12 Modem clock irregularity  Replace the FCU.
2-13 Modem initialization error  Turn off the machine, then turn it back on.
 Update the modem ROM.
 Replace the FCU.
2-22 Counter overflow error of
JBIG chip
If error occurs frequently, change the settings
for resolution, paper size, compression type.
2-23 JBIG compression or
reconstruction error
Turn off the machine, then turn it back on.
2-24 JBIG ASIC error  Turn off the machine, then turn it back on.
2-25 JBIG data reconstruction
error (BIH error)
 JBIG data error
 Check the sender’s JBIG function.
 Update the FCU ROM. 2-26 JBIG data reconstruction
error (Float marker error)