Bit Switches - 1
D702 62 SM
System Switch 09 (SP No. 1-101-010)
No Function Comments
0
Addition of image data from
confidential transmissions on
the transmission result report
0: Disabled 1: Enabled
If this feature is enabled, the top half of the first
page of confidential messages will be printed
on transmission result reports.
1
Print timing of communication
reports on the Journal when no
image data was exchanged.
0: After DCS/NSS
communication (default),
1: After polling
0: The Journal is printed only when image data
is sent.
1: The Journal is printed when any data is
sent.
2
Automatic error report printout
0: Disabled 1: Enabled
0: Error reports will not be printed.
1: Error reports will be printed automatically
after failed communications.
3
Printing of the error code on the
error report
0: No 1: Yes
1: Error codes are printed on the error reports.
This can be used for detecting an error which
occurs rarely.
4 Not used Do not change this setting.
5
Power failure report
0: Disabled
1: Enabled (default)
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when
the power was turned off last.
If "0" is selected, no reports are
printed and no one may recognize
that fax data is gone due to a power
failure.
6
Conditions for printing the
protocol dump list
0: Print for all communications
1: Print only when there is a
communication error
This switch becomes effective only when
system switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a
protocol dump list only for communications
with errors.
The memory size is limited. Use this
bit switch only when some log reports
are necessary.
To Next Page
Loading...
