TYPE M1
(D702)
Printer Switch 01 (SP No. 1-103-002)
3-4
Maximum print width used in
the setup protocol
These bits are only effective when bit 7 of
printer switch 01 is "1".
Bit 4 Bit 3 Setting
0 0 Not used
0 1 A3
1 0 B4
1 1 A4
7
Received message width
restriction in the protocol signal
to the sender
0: Disabled
1: Enabled
0: The machine informs the transmitting
machine of the print width depending on the
paper size available from the paper feed
stations.
Refer to the table on the next page for how the
machine chooses the paper width used in the
setup protocol (NSF/DIS).
1: The machine informs the transmitting
machine of the fixed paper width which is
specified by bits 3 and 4 above.
Relationship between available paper sizes and printer width used in the setup protocol
Available Paper Size Printer width used in the Protocol (NSF/DIS)
A4 or 8.5" x 11" 297 mm width
B5 256 mm width
A5 or 8.5" x 5.5" 216 mm width
No paper available (Paper end) 216 mm width
Printer Switch 02 (SP No. 1-103-003)
No Function Comments
0
1st paper feed station usage for
fax printing
0: Enabled
1: Disabled
0: The paper feed station can be used to print
fax messages and reports.
1: The specified paper feed station will not be
used for printing fax messages and reports.
Do not disable usage for a paper feed
station which has been specified by
User Parameter Switch 0F (15), or
1
2nd paper feed station usage
for fax printing
0: Enabled
1: Disabled
To Next Page
Loading...
