Bit Switches - 4
D702 96 SM
0 1 1 1 16.8 V.8 protocol on/off - G3 switch 03, bit2
1 0 0 0 19.2
1 0 0 1 21.6
1 0 1 0 24.0
1 0 1 1 26.4
1 1 0 0 28.8
1 1 0 1 31.2
Other settings - Not used
4-7
Modem types available for reception
The setting of these bits is used to inform the transmitting terminal of the available
modem type for the machine in receive mode.
If V.34 is not selected, V.8 protocol must be disabled manually.
Cross reference
V.8 protocol on/off - G3 switch 03, bit 2
Bit 7 Bit 6 Bit 5 Bit 4 Types
0 0 0 1 V.27ter
0 0 1 0 V.27ter, V.29
0 0 1 1 V.27ter, V.29, V.33
0 1 0 0 V.27ter, V.29, V.17/V.33
0 1 0 1 V.27ter, V.29, V.17/V33, V.34
Other settings - Not used
G3 Switch 07 (SP No. 1-105-008)
No Function Comments
0-1
PSTN cable equalizer
(tx mode: Internal)
Use a higher setting if there is signal
loss at higher frequencies because of
the length of wire between the modem
and the telephone exchange.
Use the dedicated transmission
parameters for specific receivers.
Also, try using the cable equalizer if one
or more of the following symptoms
occurs.
Communication error
Modem rate fallback occurs frequently.
This setting is not effective in
V.34 communications.
Bit 1 Bit 0 Setting
0 0 None
0 1 Low
1 0 Medium
1 1 High
To Next Page
Loading...
