TYPE M1
(D702)
0 1 120 s your destination return is late on the
network or G3 fax return is late, adjust the
longer interval timer.
The default is "00" (75 seconds).
1 0 180 s
1 1 240 s
6-7 Not used Do not change these settings.
IP Fax Switch 09 (SP No. 1-111-010)
No. Function Comments
0
Network I/F setting for SIP
connection
0: IPv4
1: IPv6.
Selects the connection type (IPV4 or IPV6)
to connect to the SIP server.
1
Network I/F setting for Fax
communication
0: Same setting as SIP server
connection
1: Automatic setting
0: The I/F setting for fax communication
follows the setting for SIP server
connection.
1: The negotiation between the SIP server
and the device decides whether IPv4 or
IPv6 is used for the I/F setting for fax
communication.
2
Record-route setting
0: Disable
1: Enable
0: Disables the record-route function of the
SIP server.
1: Enables the record-route function of the
SIP server.
3-4
re-INVITE transmission delay timer
setting
This changes the interval for transmit
re-INVITE after receiving the ACK message
transmitted by T.38 device.
Bit 4 Bit 3
0 0 No delay
0 1 1 sec
1 0 2 sec
1 1 3 sec
5
SIP-IPFAX: Adding vender
information selection
0: Declare T38VendorInfo=RICOH
1: Not declare
T38VendorInfo=RICOH
To Next Page
