Ricoh D158 - Page 958

NCU Parameters
D702 116 SM
Address Function Unit Remarks
6805A2
Acceptable CED detection
frequency upper limit (low byte)
detection is disabled.
6805A3
Acceptable CED detection
frequency lower limit (high byte)
BCD (Hz)
If both addresses
contain FF(H), tone
detection is disabled. 6805A4
Acceptable CED detection
frequency lower limit (low byte)
6805A5 CED detection time
20 ms ± 20
ms
Factory setting: 200 ms
6805A6
Acceptable CNG detection
frequency upper limit (high byte)
BCD (Hz)
If both addresses
contain FF(H), tone
detection is disabled. 6805A7
Acceptable CNG detection
frequency upper limit (low byte)
6805A8
Acceptable CNG detection
frequency lower limit (high byte)
BCD (Hz)
If both addresses
contain FF(H), tone
detection is disabled. 6805A9
Acceptable CNG detection
frequency lower limit (low byte)
6805AA Not used -
Do not change the
setting.
6805AB CNG on time 20 ms Factory setting: 500 ms
6805AC CNG off time 20 ms
Factory setting: 3000
ms
6805AD
Number of CNG cycles required
for detection
-
The data is coded in the
same way as address
680533.
6805AE Not used -
Do not change the
settings.
6805AF
Acceptable AI short protocol tone
(800Hz) detection frequency
upper limit (high byte)
Hz (BCD)
If both addresses
contain FF(H), tone
detection is disabled.
6805B0
Acceptable AI short protocol tone
(800Hz) detection frequency
upper limit (low byte)
6805B1
Acceptable AI short protocol tone
(800Hz) detection frequency
lower limit (high byte)
Hz(BCD)
If both addresses
contain FF(H), tone
detection is disabled.