Ricoh Pro C5200s - SC Code List

SC Code List
This table contains a list of selected SC codes. If the SC code that is displayed on the control panel is
listed in this table, carry out the recommended procedure. If the SC Code is not listed in this table,
contact your service representative.
• If the error persists after replacing the unit, contact your service representative.
Code Error Procedure
332-01 Toner supply motor error (K): Bottle Take out and reinsert the toner (black) or
replace it.
332-02 Toner supply motor error (C): Bottle Take out and reinsert the toner (cyan) or
replace it.
332-03 Toner supply motor error (M): Bottle Take out and reinsert the toner (magenta)
or replace it.
332-04 Toner supply motor error (Y): Bottle Take out and reinsert the toner (yellow)
or replace it.
410-01 Remaining potential: Vr detection error (K) Replace the photoconductor unit (black).
410-02 Remaining potential: Vr detection error (C) Replace the photoconductor unit (cyan).
410-03 Remaining potential: Vr detection error (M) Replace the photoconductor unit
(magenta).
410-04 Remaining potential: Vr detection error (Y) Replace the photoconductor unit
(yellow).
411-01 Charge potential: Vd adjustment error (K) Replace the charge roller unit (black).
411-02 Charge potential: Vd adjustment error (C) Replace the charge roller unit (cyan).
411-03 Charge potential: Vd adjustment error (M) Replace the charge roller unit (magenta).
411-04 Charge potential: Vd adjustment error (Y) Replace the charge roller unit (yellow).
412-01 Exposure potential: Vpl adjustment error (K) Replace the photoconductor unit (black)
and the charge roller unit (black).
412-02 Exposure potential: Vpl adjustment error (C) Replace the photoconductor unit (cyan)
and the charge roller unit (cyan).
2. Troubleshooting Service Call Problems (SC Codes)
14