Coated paper is being used.
In the [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set [Output Fan
Level] to [Increase Air Volume].
There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
Printed sheets are curled.
Load the sheets the other way up.
There are too many stacked sheets.
Reduce the number of the stacked sheets. To do this, suspend printing and remove the stacked sheets,
and then resume printing.
To suspend printing, press the [Suspend/Resume] key on the finisher.
To resume printing, press the [Suspend/Resume] key on the finisher.
Thin coated paper is used.
When stapling thin coated paper, the stapled sheets may be scratched or they may jam.
Large Delivered Sheets Are Not Stacked Properly (Finisher SR5070 / Booklet
Finisher SR5080)
Cause:
When using large-size or coated and paper-to-paper friction is very high, a sheet may push against
another or paper deflection may occur.
This may occur if:
• B4 , 8
1
/
2
" 14" , or larger size of paper is used.
• Paper that produces high paper-to-paper friction is used.
• The temperature or humidity is high.
Sheet bending
The leading edge of the delivered sheet bends upward and backward.
Finisher
89
To Next Page
Loading...
