Paper feed direction
Leading-edge margin Trailing-edge margin
CEZ586
Solution:
Adjust the leading/trailing edge margins.
1. In [Advanced Settings] for the custom paper in use, reduce the value by 0.5 mm in [Erase
Margin: Leading Edge].
2. Reduce the value by 0.5 mm in [Erase Margin: Trailing Edge].
3. Print the image. Is the problem resolved?
Yes Finished!
No If this results in a paper jam during duplex printing, restore the previous setting.
• The adjusted margin cannot be applied to masked images that are solid-filled or contain ruled lines
at the leading/trailing edges.
• Reducing the leading/trailing edge margin may result in a paper jam on the fusing belt stripper
plate.
Curling
To eliminate curling without using the decurler unit, lower the heat roller temperature.
Lowering the temperature may result in:
• Unsatisfactory fusing
• Reduced glossiness
• Smeared for halftone images on uncoated paper
1. In [Advanced Settings] for the custom paper in use, select [Fusing Temp] and reduce the
value by 5 °C.
4. Troubleshooting Paper Delivery Problems
82
To Next Page
Loading...
