Ricoh Pro C5200s Operating Instructions Troubleshooting: Tcru/Oru

Gloss Problems
Glossy Lines
Glossy lines appear every 20 or 26.5 mm (0.8 or 1.0 inches).
20 mm or 26.5 mm
(0.8 or 1.0 in.)
CEZ570
Cause:
This may occur if coated or thin paper is used.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings Reference.
• If the glossy lines appear at irregular intervals, you cannot resolve the problem with this procedure.
Contact your service representative.
• Decreasing the fusing temperature may produce one or more of the following side effects:
• Insufficient toner fusing
• Insufficient gloss
• Halftone images on uncoated paper are soiled
Solution:
1. Print the image on twenty sheets. Do glossy lines appear on the tenth sheet and later
sheets?
Yes Go to the next step.
No You cannot resolve the problem with this procedure. Contact your service representative.
Gloss Problems
61

Ricoh Pro C5200s Specifications

General

Print Technology	Laser
Max Paper Size	330.2 x 487.7 mm
Monthly Duty Cycle	300, 000 pages
Print Speed	65 ppm
Resolution	1200 x 4800 dpi
Paper Input Capacity	8, 250 sheets
Paper Weight	52 to 360 gsm
Duplex Printing	Standard
Network Connectivity	Ethernet 10Base-T/100Base-TX/1000Base-T
Supported Media Sizes	A3, A4, A5, B4, B5
Supported Media Types	Plain, Recycled, Coated, Envelope
Warm-up Time	Less than 5 minutes