Toner Scatter (3)
Parts of a line or character exhibit splatter. This may occur in a line or character that is 8 to 13 mm (0.3
to 0.5 inches) from the trailing edge and 20 mm (0.8 inches) or less from the left edge facing the paper
feed direction.
8-13 mm (0.3-0.5 in.)
20 mm (0.8 in.)
CNT009
Cause:
A shock jitter occurs when the trailing edge of the paper leaves the paper guide during paper transfer
and causes toner scattering.
This may occur if paper with a thickness equivalent to Paper Weight 4 or higher is used.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings Reference.
• Changing the transfer current may produce either or both of the following side effects:
• Reduction in toner yields
• Occurrence of banding (streaks)
Solution:
<Printing in full color>
1. In [Advanced Settings] for the custom paper in use, select [Image Transfer Current: FC: K].
Toner Scatter
33
To Next Page
Loading...
